- ICOM RS BA1 REMOTE 4SHARED INSTALL
- ICOM RS BA1 REMOTE 4SHARED SOFTWARE
- ICOM RS BA1 REMOTE 4SHARED PC
(For a single band on only the IC-7851, 78)
The spectrum scope with the waterfall function can be observed on the RS-BA1. Slider control or tuning knob control screens are selectable for RF power, CW pitch, RF gain, and SQL and AF level. Remote power ON/OFF function wakes up certain transceivers from the standby mode.Īdvanced Remote Control Interface Tailored to Icom Transceivers. Make sure you ALSO connect the relevant 3 UDP ports on the Remote PC using the internet to connect to the radio. Make sure you open the relevant 3 UDP ports on the PC connected to the Radio physically.
Most functions and modes of your transceiver, including interference rejection functions and IF filter settings, can be controlled using CI-V commands. Icom RS-BA1 Remote Controller: Cheat Sheet A few random tips in case I forget later. Low latency, high quality audio over an IP network. even from a remote location over the Internet. The RS-BA1 allows you to use the radio installed in another room using your home network or. The RS-BA1 allows you to use the transceiver installed in another room using your home network or even from a remote location over the Internet. Remotely Control Icom Transceivers through an IP Network. Scroll down on that page to find the RS-BA1 section. After installing those from the CD-ROM, go to the Icom website and install the latest update.
Remotely Control Icom Transceivers through an IP Network The Remote Utility software and the Remote Control software. …įor more information about the IC-7300 visit: …īoth the RC-28 IP Remote Control System and IC-7300 are both available from all authorised Icom Dealers. To found out more visit the RC-28 IP Remote Control System page where you will also find a list of compatible Icom HF radios. Introduction to the RC-28 remote controller encoder.
Installing the RS-BA1 remote control software. The spectrum scope functions (single receive) are usable with the IC-7300, IC-9700 and IC-705. The dualwatch and dual spectrum scope functions are only for the IC-7851, IC-7850 and IC-7610. Of course, the RS-BA1 can be used with Icom single receiver transceivers. The video shows Bob McCreadie (G0FGX) of TX Films demonstrating: MAIN and SUB spectrum scopes can be observed on the RS-BA1 at the same time. Our friends at the TX Factor have produced a video that logically goes through the step by set process of remote controlling an Icom Amateur radio, more specifically in this case, the IC-7300 using the RS-BA1 remote control software.
0 kommentar(er)
